1、生化培養箱在運送、檢修、維護保養時，應防止撞擊，晃動振動;zui大坡度低于45度。

1. When the biochemical incubator is being transported, repaired and maintained, it should prevent impact and shaking vibration; Zui slope is less than 45 degrees.

2、工作時，應避免頻繁開門，以保持溫度穩定，同時防止灰塵污物進入。

2. When working, frequent door opening should be avoided in order to keep the temperature stable and prevent dust and dirt from entering.

3、打開前要全方位了解和掌握各構成配套設施儀器設備、儀表盤的使用說明、把握恰當?shù)氖褂谜f明。

3. Before opening, we should fully understand and master the instructions for the use of instruments and equipments, dashboards and appropriate instructions.

4、不宜在高電壓、大電流、強磁場等反常環境下使用生化培養箱，以免干擾損壞及發生危險。

4. Biochemical incubator should not be used in abnormal environment such as high voltage, high current and strong magnetic field to avoid disturbance, damage and danger.

5、箱里外應每天清潔，每一次應用結束理應開展清理。長期性無需應蓋好塑膠防塵套，放到干躁房間內，另外，箱壁內膽和機器設備表層要常常檫拭，以清潔，提升夾層玻璃的清晰度。

5. The inside and outside of the box should be cleaned every day. Cleaning should be carried out at the end of each application. For a long time, it is not necessary to cover the plastic dust-proof cover and put it in the dry room. In addition, the inner liner of the box wall and the surface of the mechanical equipment should be wiped frequently to clean and improve the clarity of the laminated glass.

6、盡可能地安裝于空氣清靜，溫度變化較小的地方，使用三腳插頭，插座應妥善接地。

6. Install as far as possible in a place where the air is quiet and the temperature changes are small. Use a tripod plug and the socket should be properly grounded.

7、清理生化培養箱的那時候，用侵泡乙醇的沙布擦洗殼體內腔開展殺菌消毒殺菌，隨后用干沙布將乙醇擦掉整潔。

7. When the biochemical incubator is cleaned, the inner cavity of the shell is scrubbed with a sand cloth soaked with ethanol to carry out sterilization and disinfection, and then the ethanol is wiped clean with a dry sand cloth.

8、經常注意氣路有無漏氣現象。

8. Always pay attention to air leakage.

9、為確保冷卻器合理地?zé)峁苌?，冷卻器與墻壁之間間距應超過100mm。殼體側邊需有50mm空隙，殼體頂端最少需有300mm室內空間。

9. In order to ensure the rational heat pipe heat dissipation of the cooler, the distance between the cooler and the wall should exceed 100 mm. The side of the shell needs 50 mm space, and the top of the shell needs at least 300 mm indoor space.

10、嚴禁含有易揮發性化學溶劑，爆炸性氣體和可燃性氣體置于箱內;培養箱附近不可使用可燃性噴霧劑，以免電火花引燃。

10. It is strictly forbidden to contain volatile chemical solvents, explosive gases and flammable gases in the box; flammable sprays should not be used near the incubator in order to avoid spark ignition.

11、停用，關掉總鎖屏鍵，及機器設備后側的電源總開關。

11. Discontinue, turn off the main lock screen key and the main power switch at the back of the machine and equipment.

http://www.lomiko.cn/